Description

Technical Parameters

Product characteristics

1. Cross roller guide and cylinder integrated design, so that the cylinder has high strength, high precision, high load characteristics, and has excellent straightness and non-rotating accuracy, more suitable for precision assembly occasions.

2. The guide rail is equipped with positioning pin holes.

3. The piston rod is designed with floating joint and does not bear extra load torque.

4. Double piston rod design, can get double output.

5. The body is equipped with positioning pin holes.

6. Mounting holes are attached to the bottom and end surfaces of the body.

Specification

Bore size(mm)	6	8	12	16	20	25
Acting type	Double acting
Fluid	Air(to be filtered by 40μm filter element)
Operating pressure	0.2-0.7MPa(29~100psi)(20-7.0bar)		0.15~0.7MPa(22~100psi)(1.5~7.0bar)
Proof pressure	1.2MPa(175psi)(12.0bar)
Temperature℃	-20~70
Speed range mm/s	50~500
Stroke tolerance	Stroke≤100^{+1.0 0} Stroke>100^{+1.5 0}
Cushion type	Bumper(Both ends),Shock absorber
Sensor switches	CMSH,DMSH,EMSH
Port size [Note1]	M5x0.8				PT1/8

[Note]

PT thread,G thread, NPT thread are available.

Stroke

Bore size (mm)	Standard stroke(mm)	Max.std stroke
10	10 20 30 40 50 60 70 80 90 100	100
16	10 20 30 40 50 60 70 80 90 100 125 150 175 200	200
20	10 20 30 40 50 60 70 80 90 100 125 150 175 200	200
25	10 20 30 40 50 60 70 80 90 100 125 150 175 200	200
32	10 20 30 40 50 60 70 80 90 100 125 150 175 200	200

[Note]

Consult us for non-standard stroke.

Installation and use

1.Before the cylinder piping, it is necessary to remove the debris in the tube to prevent debris from entering the cylinder;

2.The medium used by the cylinder should be filtered by the filter element above 40μm before it can be used;

3.In the low temperature environment, anti-freezing measures should be taken to prevent the freezing of water in the system;

4.If the cylinder is removed and not used for a long time, pay attention to surface rust prevention. The inlet and exhaust ports should be coated with dust blocking cap piston rod and anti-rust oil on the moving parts.

FAQ

Q: What is the point of cylinders?

A: A cylinder is a vital part of the engine. It's a chamber where fuel is combusted and power is generated. The cylinder consists of a piston and two valves at the top; an inlet and exhaust valves. The piston moves up and down, and its reciprocating motion generates power that moves your vehicle.

Q: What is a cylindrical slide rule?

A: Writing a logarithmic scale in a spiral that is then imprinted around the outside of a cylinder allows instrument makers to lengthen the scale.

Q: Do cylinders roll or slide?

A: If we put them standing up on their flat surface and push them, they'll slide. But cylinders also have a curved surface too. And if we turn this cylinder on its side and push it, it's going to roll. So a cylinder is a really good example of a shape that we can roll, stack, and slide.

Hot Tags: hls series slide table cylinder, China hls series slide table cylinder manufacturers, suppliers, factory, double guide rod piston slide cylinder, hlh series slide table cylinder, hlq series slide table cylinder, hls series slide table cylinder, mxs seriesair slide table cylinder, slide table cylinders

HLS Series Slide Table Cylinder

Product characteristics

Specification

Stroke

Installation and use

FAQ