Description

Technical Parameters

Product characteristics

1. The material of the seal ensures the reliable performance of the cylinder under various conditions;

2. three guide groove structure, high guidance accuracy;

3. the working mode has unilateral and bilateral (90°);

4. rotation mode has left and right rotation; 90°and 180°;

5. the piston rod material is special alloy steel, after heat treatment, can ensure longer service life.

Specification

Bore size(mm)	25	32	40	50	63
Acting type	Double acting
Fluid	Air(to be filtered by 40μm filter element)
Operating pressure	0.15~1.0MPa(22~145psi)
Proof pressure	1.5MPa(215psi)
Temperature℃	-20~70
Speed range	50~200
Stroke tolerance	+1.0 0
Rotation angle tolerance	±1.5°
Cushion type [Note1]	None
Port size [Note2]	M5×0.8	PT1/8

[Note1]

If there is no buffer installation, please add exhaust throttle device to achieve buffer effect.

[Note2]

PT thread,G thread are available.

Stroke

Bore size(mm)	Stroke type	90°	180°	Total stroke(90°/180°)
25 32	Rotating stroke	14	20	26
25 32	Clamping stroke	12	6	26
40	Rotating stroke	15	21	27
40	Clamping stroke	12	6	27
50 63	Rotating stroke	15	21	29
50 63	Clamping stroke	14	8	29

Installation and Use

1.The cylinder clamping work piece must be carried out in the clamping stroke, not in the rotating stroke clamping operation.

2.The clamping plane must be perpendicular to the cylinder axis, the work piece is clamped, please do not move the work piece.

3.Before the cylinder piping, it is necessary to remove the debris in the tube to prevent debris from entering the cylinder.

4.The medium used by the cylinder should be filtered by more than 40um filter element before it can be used.

5.The cylinder is not used for a long time, pay attention to the anti-embroidery surface, the inlet and exhaust port should be dust-proof tower plug cap, and the piston rod end is coated with anti-rust oil.

FAQ

Q: How does a clamping mechanism work?

A: Actuating the clamp first moves it into position, then applies clamping force by compressing or stretching the linkage elements after contacting the workpiece, then positively locks it by moving the toggle action's center pivot past the centerline of the other two pivots, against a stop.

Q: What is the rotating cylinder method?

A: A rotating cylinder induces a velocity gradient in the wind from which a lateral force results. On the opposite side, b, the cylinder impels the air from left to right, causing it to flow faster than the stream and establishing a velocity gradient. The average stream velocity is larger on the b-side than on the a-side.

Q: What are the basic principle of clamping?

A: Clamping design principles The basics of clamping design should be noted: 1. Strong enough to hold the work piece and resist the shifting of the work piece 2. Not damage / deform work piece 3. Guarantee loading and unloading of work piece quickly.

Hot Tags: ack 90 degrees twist clamp cylinder, China ack 90 degrees twist clamp cylinder manufacturers, suppliers, factory, ack 90 degrees twist clamp cylinder, fz25p auxiliary support air cylinder, fz32q floating support air cylinder, rotary angle src standard rotary cylinder, rotary clamp cylinder, src rotary clamping corner pressing cylinder

ACK 90 Degrees Twist Clamp Cylinder

Product characteristics

Specification

Stroke

Installation and Use

FAQ